Front Page Forums 4700 Imaging manuals or advice…

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #1108
    Richard Goodwin

    I am currently using our Ultraflex II to do MALDI imaging with reasonable success, however I’d now like to use our 4700 (with plate loader) to do some high throughput analysis and was after any advice.

    I have installed BioMap and 4000 series imaging but can not find any information/manuals on the website…I was wondering if I’m just being stupid and can’t find them.

    Any advice would be gratefully received.

    Many thanks




    Hmmm, there is no manual for the 4700 imaging software. There is a short description at the bottom of Home > Software > 4000 Series Imaging.
    I think this is sufficient. The rest of the 4700 imaging software and how to acquire images is more or less self-explaning.
    BioMAP is a little bit more complicated and not everything is there that obvious. As written at Home > Software > BioMap some functions are described in the manual which you can find at the installation path of BioMap on your computer.
    Good luck!


Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.